In the Linux kernel, the following vulnerability has been resolved: crypto: stm32/cryp - call finalize with bh disabled The finalize operation in interrupt mode produce a produces a spinlock recursion warning. The reason is the fact that BH must be disabled during this process.

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Correct the defined value for AMDGPU_DMUB_NOTIFICATION_MAX [Why & How] It actually exposes '6' types in enum dmub_notification_type. Not 5. Using smaller number to create array dmub_callback & dmub_thread_offload has potential to access item out of array bound. Fix it.

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Disable DMCUB timeout for DCN35 [Why] DMCUB can intermittently take longer than expected to process commands. Old ASIC policy was to continue while logging a diagnostic error - which works fine for ASIC without IPS, but with IPS this could lead to a race condition where we attempt to access DCN state while it's inaccessible, leading to a system hang when the NIU port is not disabled or register accesses that timeout and the display configuration in an undefined state. [How] We need to investigate why these accesses take longer than expected, but for now we should disable the timeout on DCN35 to avoid this race condition. Since the waits happen only at lower interrupt levels the risk of taking too long at higher IRQ and causing a system watchdog timeout are minimal.

In the Linux kernel, the following vulnerability has been resolved: ASoC: Intel: soc-acpi-intel-lnl-match: add missing empty item There is no links_num in struct snd_soc_acpi_mach {}, and we test !link->num_adr as a condition to end the loop in hda_sdw_machine_select(). So an empty item in struct snd_soc_acpi_link_adr array is required.

In the Linux kernel, the following vulnerability has been resolved: usbnet: ipheth: do not stop RX on failing RX callback RX callbacks can fail for multiple reasons: * Payload too short * Payload formatted incorrecly (e.g. bad NCM framing) * Lack of memory None of these should cause the driver to seize up. Make such failures non-critical and continue processing further incoming URBs.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7921: fix NULL pointer access in mt7921_ipv6_addr_change When disabling wifi mt7921_ipv6_addr_change() is called as a notifier. At this point mvif->phy is already NULL so we cannot use it here.

In the Linux kernel, the following vulnerability has been resolved: platform/x86: panasonic-laptop: Fix SINF array out of bounds accesses The panasonic laptop code in various places uses the SINF array with index values of 0 - SINF_CUR_BRIGHT(0x0d) without checking that the SINF array is big enough. Not all panasonic laptops have this many SINF array entries, for example the Toughbook CF-18 model only has 10 SINF array entries. So it only supports the AC+DC brightness entries and mute. Check that the SINF array has a minimum size which covers all AC+DC brightness entries and refuse to load if the SINF array is smaller. For higher SINF indexes hide the sysfs attributes when the SINF array does not contain an entry for that attribute, avoiding show()/store() accessing the array out of bounds and add bounds checking to the probe() and resume() code accessing these.

In the Linux kernel, the following vulnerability has been resolved: perf/x86/intel: Limit the period on Haswell Running the ltp test cve-2015-3290 concurrently reports the following warnings. perfevents: irq loop stuck! WARNING: CPU: 31 PID: 32438 at arch/x86/events/intel/core.c:3174 intel_pmu_handle_irq+0x285/0x370 Call Trace: <NMI> ? __warn+0xa4/0x220 ? intel_pmu_handle_irq+0x285/0x370 ? __report_bug+0x123/0x130 ? intel_pmu_handle_irq+0x285/0x370 ? __report_bug+0x123/0x130 ? intel_pmu_handle_irq+0x285/0x370 ? report_bug+0x3e/0xa0 ? handle_bug+0x3c/0x70 ? exc_invalid_op+0x18/0x50 ? asm_exc_invalid_op+0x1a/0x20 ? irq_work_claim+0x1e/0x40 ? intel_pmu_handle_irq+0x285/0x370 perf_event_nmi_handler+0x3d/0x60 nmi_handle+0x104/0x330 Thanks to Thomas Gleixner's analysis, the issue is caused by the low initial period (1) of the frequency estimation algorithm, which triggers the defects of the HW, specifically erratum HSW11 and HSW143. (For the details, please refer https://lore.kernel.org/lkml/87plq9l5d2.ffs@tglx/) The HSW11 requires a period larger than 100 for the INST_RETIRED.ALL event, but the initial period in the freq mode is 1. The erratum is the same as the BDM11, which has been supported in the kernel. A minimum period of 128 is enforced as well on HSW. HSW143 is regarding that the fixed counter 1 may overcount 32 with the Hyper-Threading is enabled. However, based on the test, the hardware has more issues than it tells. Besides the fixed counter 1, the message 'interrupt took too long' can be observed on any counter which was armed with a period < 32 and two events expired in the same NMI. A minimum period of 32 is enforced for the rest of the events. The recommended workaround code of the HSW143 is not implemented. Because it only addresses the issue for the fixed counter. It brings extra overhead through extra MSR writing. No related overcounting issue has been reported so far.

In the Linux kernel, the following vulnerability has been resolved: um: line: always fill *error_out in setup_one_line() The pointer isn't initialized by callers, but I have encountered cases where it's still printed; initialize it in all possible cases in setup_one_line().

In the Linux kernel, the following vulnerability has been resolved: scsi: ufs: core: Remove SCSI host only if added If host tries to remove ufshcd driver from a UFS device it would cause a kernel panic if ufshcd_async_scan fails during ufshcd_probe_hba before adding a SCSI host with scsi_add_host and MCQ is enabled since SCSI host has been defered after MCQ configuration introduced by commit 0cab4023ec7b ("scsi: ufs: core: Defer adding host to SCSI if MCQ is supported"). To guarantee that SCSI host is removed only if it has been added, set the scsi_host_added flag to true after adding a SCSI host and check whether it is set or not before removing it.

In the Linux kernel, the following vulnerability has been resolved: scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the routine unconditionally frees submitted mailbox commands regardless of return status. The issue is that for MBX_TIMEOUT cases, when firmware returns SFP information at a later time, that same mailbox memory region references previously freed memory in its cmpl routine. Fix by adding checks for the MBX_TIMEOUT return code. During mailbox resource cleanup, check the mbox flag to make sure that the wait did not timeout. If the MBOX_WAKE flag is not set, then do not free the resources because it will be freed when firmware completes the mailbox at a later time in its cmpl routine. Also, increase the timeout from 30 to 60 seconds to accommodate boot scripts requiring longer timeouts.

In the Linux kernel, the following vulnerability has been resolved: btrfs: don't BUG_ON on ENOMEM from btrfs_lookup_extent_info() in walk_down_proc() We handle errors here properly, ENOMEM isn't fatal, return the error.

In the Linux kernel, the following vulnerability has been resolved: btrfs: clean up our handling of refs == 0 in snapshot delete In reada we BUG_ON(refs == 0), which could be unkind since we aren't holding a lock on the extent leaf and thus could get a transient incorrect answer. In walk_down_proc we also BUG_ON(refs == 0), which could happen if we have extent tree corruption. Change that to return -EUCLEAN. In do_walk_down() we catch this case and handle it correctly, however we return -EIO, which -EUCLEAN is a more appropriate error code. Finally in walk_up_proc we have the same BUG_ON(refs == 0), so convert that to proper error handling. Also adjust the error message so we can actually do something with the information.

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: aspeed_udc: validate endpoint index for ast udc We should verify the bound of the array to assure that host may not manipulate the index to point past endpoint array. Found by static analysis.

In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu: Fix smatch static checker warning adev->gfx.imu.funcs could be NULL

In the Linux kernel, the following vulnerability has been resolved: ethtool: fail closed if we can't get max channel used in indirection tables Commit 0d1b7d6c9274 ("bnxt: fix crashes when reducing ring count with active RSS contexts") proves that allowing indirection table to contain channels with out of bounds IDs may lead to crashes. Currently the max channel check in the core gets skipped if driver can't fetch the indirection table or when we can't allocate memory. Both of those conditions should be extremely rare but if they do happen we should try to be safe and fail the channel change.

In the Linux kernel, the following vulnerability has been resolved: net: hns3: void array out of bound when loop tnl_num When query reg inf of SSU, it loops tnl_num times. However, tnl_num comes from hardware and the length of array is a fixed value. To void array out of bound, make sure the loop time is not greater than the length of array

In the Linux kernel, the following vulnerability has been resolved: MIPS: cevt-r4k: Don't call get_c0_compare_int if timer irq is installed This avoids warning: [ 0.118053] BUG: sleeping function called from invalid context at kernel/locking/mutex.c:283 Caused by get_c0_compare_int on secondary CPU. We also skipped saving IRQ number to struct clock_event_device *cd as it's never used by clockevent core, as per comments it's only meant for "non CPU local devices".

In the Linux kernel, the following vulnerability has been resolved: rtmutex: Drop rt_mutex::wait_lock before scheduling rt_mutex_handle_deadlock() is called with rt_mutex::wait_lock held. In the good case it returns with the lock held and in the deadlock case it emits a warning and goes into an endless scheduling loop with the lock held, which triggers the 'scheduling in atomic' warning. Unlock rt_mutex::wait_lock in the dead lock case before issuing the warning and dropping into the schedule for ever loop. [ tglx: Moved unlock before the WARN(), removed the pointless comment, massaged changelog, added Fixes tag ]

In the Linux kernel, the following vulnerability has been resolved: arm64: acpi: Harden get_cpu_for_acpi_id() against missing CPU entry In a review discussion of the changes to support vCPU hotplug where a check was added on the GICC being enabled if was online, it was noted that there is need to map back to the cpu and use that to index into a cpumask. As such, a valid ID is needed. If an MPIDR check fails in acpi_map_gic_cpu_interface() it is possible for the entry in cpu_madt_gicc[cpu] == NULL. This function would then cause a NULL pointer dereference. Whilst a path to trigger this has not been established, harden this caller against the possibility.