In the Linux kernel, the following vulnerability has been resolved: PCI: keystone: Add workaround for Errata #i2037 (AM65x SR 1.0) Errata #i2037 in AM65x/DRA80xM Processors Silicon Revision 1.0 (SPRZ452D_July 2018_Revised December 2019 [1]) mentions when an inbound PCIe TLP spans more than two internal AXI 128-byte bursts, the bus may corrupt the packet payload and the corrupt data may cause associated applications or the processor to hang. The workaround for Errata #i2037 is to limit the maximum read request size and maximum payload size to 128 bytes. Add workaround for Errata #i2037 here. The errata and workaround is applicable only to AM65x SR 1.0 and later versions of the silicon will have this fixed. [1] -> https://www.ti.com/lit/er/sprz452i/sprz452i.pdf

In the Linux kernel, the following vulnerability has been resolved: scsi: pm80xx: Set phy->enable_completion only when we wait for it pm8001_phy_control() populates the enable_completion pointer with a stack address, sends a PHY_LINK_RESET / PHY_HARD_RESET, waits 300 ms, and returns. The problem arises when a phy control response comes late. After 300 ms the pm8001_phy_control() function returns and the passed enable_completion stack address is no longer valid. Late phy control response invokes complete() on a dangling enable_completion pointer which leads to a kernel crash.

In the Linux kernel, the following vulnerability has been resolved: i3c: mipi-i3c-hci: Error out instead on BUG_ON() in IBI DMA setup Definitely condition dma_get_cache_alignment * defined value > 256 during driver initialization is not reason to BUG_ON(). Turn that to graceful error out with -EINVAL.

In the Linux kernel, the following vulnerability has been resolved: spi: hisi-kunpeng: Add verification for the max_frequency provided by the firmware If the value of max_speed_hz is 0, it may cause a division by zero error in hisi_calc_effective_speed(). The value of max_speed_hz is provided by firmware. Firmware is generally considered as a trusted domain. However, as division by zero errors can cause system failure, for defense measure, the value of max_speed is validated here. So 0 is regarded as invalid and an error code is returned.

In the Linux kernel, the following vulnerability has been resolved: staging: iio: frequency: ad9834: Validate frequency parameter value In ad9834_write_frequency() clk_get_rate() can return 0. In such case ad9834_calc_freqreg() call will lead to division by zero. Checking 'if (fout > (clk_freq / 2))' doesn't protect in case of 'fout' is 0. ad9834_write_frequency() is called from ad9834_write(), where fout is taken from text buffer, which can contain any value. Modify parameters checking. Found by Linux Verification Center (linuxtesting.org) with SVACE.

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Remove register from DCN35 DMCUB diagnostic collection [Why] These registers should not be read from driver and triggering the security violation when DMCUB work times out and diagnostics are collected blocks Z8 entry. [How] Remove the register read from DCN35.

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Avoid overflow from uint32_t to uint8_t [WHAT & HOW] dmub_rb_cmd's ramping_boundary has size of uint8_t and it is assigned 0xFFFF. Fix it by changing it to uint8_t with value of 0xFF. This fixes 2 INTEGER_OVERFLOW issues reported by Coverity.

In the Linux kernel, the following vulnerability has been resolved: fsnotify: clear PARENT_WATCHED flags lazily In some setups directories can have many (usually negative) dentries. Hence __fsnotify_update_child_dentry_flags() function can take a significant amount of time. Since the bulk of this function happens under inode->i_lock this causes a significant contention on the lock when we remove the watch from the directory as the __fsnotify_update_child_dentry_flags() call from fsnotify_recalc_mask() races with __fsnotify_update_child_dentry_flags() calls from __fsnotify_parent() happening on children. This can lead upto softlockup reports reported by users. Fix the problem by calling fsnotify_update_children_dentry_flags() to set PARENT_WATCHED flags only when parent starts watching children. When parent stops watching children, clear false positive PARENT_WATCHED flags lazily in __fsnotify_parent() for each accessed child.

In the Linux kernel, the following vulnerability has been resolved: smack: tcp: ipv4, fix incorrect labeling Currently, Smack mirrors the label of incoming tcp/ipv4 connections: when a label 'foo' connects to a label 'bar' with tcp/ipv4, 'foo' always gets 'foo' in returned ipv4 packets. So, 1) returned packets are incorrectly labeled ('foo' instead of 'bar') 2) 'bar' can write to 'foo' without being authorized to write. Here is a scenario how to see this: * Take two machines, let's call them C and S, with active Smack in the default state (no settings, no rules, no labeled hosts, only builtin labels) * At S, add Smack rule 'foo bar w' (labels 'foo' and 'bar' are instantiated at S at this moment) * At S, at label 'bar', launch a program that listens for incoming tcp/ipv4 connections * From C, at label 'foo', connect to the listener at S. (label 'foo' is instantiated at C at this moment) Connection succeedes and works. * Send some data in both directions. * Collect network traffic of this connection. All packets in both directions are labeled with the CIPSO of the label 'foo'. Hence, label 'bar' writes to 'foo' without being authorized, and even without ever being known at C. If anybody cares: exactly the same happens with DCCP. This behavior 1st manifested in release 2.6.29.4 (see Fixes below) and it looks unintentional. At least, no explanation was provided. I changed returned packes label into the 'bar', to bring it into line with the Smack documentation claims.

In the Linux kernel, the following vulnerability has been resolved: crypto: stm32/cryp - call finalize with bh disabled The finalize operation in interrupt mode produce a produces a spinlock recursion warning. The reason is the fact that BH must be disabled during this process.

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Correct the defined value for AMDGPU_DMUB_NOTIFICATION_MAX [Why & How] It actually exposes '6' types in enum dmub_notification_type. Not 5. Using smaller number to create array dmub_callback & dmub_thread_offload has potential to access item out of array bound. Fix it.

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Disable DMCUB timeout for DCN35 [Why] DMCUB can intermittently take longer than expected to process commands. Old ASIC policy was to continue while logging a diagnostic error - which works fine for ASIC without IPS, but with IPS this could lead to a race condition where we attempt to access DCN state while it's inaccessible, leading to a system hang when the NIU port is not disabled or register accesses that timeout and the display configuration in an undefined state. [How] We need to investigate why these accesses take longer than expected, but for now we should disable the timeout on DCN35 to avoid this race condition. Since the waits happen only at lower interrupt levels the risk of taking too long at higher IRQ and causing a system watchdog timeout are minimal.

In the Linux kernel, the following vulnerability has been resolved: ASoC: Intel: soc-acpi-intel-lnl-match: add missing empty item There is no links_num in struct snd_soc_acpi_mach {}, and we test !link->num_adr as a condition to end the loop in hda_sdw_machine_select(). So an empty item in struct snd_soc_acpi_link_adr array is required.

In the Linux kernel, the following vulnerability has been resolved: usbnet: ipheth: do not stop RX on failing RX callback RX callbacks can fail for multiple reasons: * Payload too short * Payload formatted incorrecly (e.g. bad NCM framing) * Lack of memory None of these should cause the driver to seize up. Make such failures non-critical and continue processing further incoming URBs.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7921: fix NULL pointer access in mt7921_ipv6_addr_change When disabling wifi mt7921_ipv6_addr_change() is called as a notifier. At this point mvif->phy is already NULL so we cannot use it here.

In the Linux kernel, the following vulnerability has been resolved: platform/x86: panasonic-laptop: Fix SINF array out of bounds accesses The panasonic laptop code in various places uses the SINF array with index values of 0 - SINF_CUR_BRIGHT(0x0d) without checking that the SINF array is big enough. Not all panasonic laptops have this many SINF array entries, for example the Toughbook CF-18 model only has 10 SINF array entries. So it only supports the AC+DC brightness entries and mute. Check that the SINF array has a minimum size which covers all AC+DC brightness entries and refuse to load if the SINF array is smaller. For higher SINF indexes hide the sysfs attributes when the SINF array does not contain an entry for that attribute, avoiding show()/store() accessing the array out of bounds and add bounds checking to the probe() and resume() code accessing these.

In the Linux kernel, the following vulnerability has been resolved: mptcp: pm: Fix uaf in __timer_delete_sync There are two paths to access mptcp_pm_del_add_timer, result in a race condition: CPU1 CPU2 ==== ==== net_rx_action napi_poll netlink_sendmsg __napi_poll netlink_unicast process_backlog netlink_unicast_kernel __netif_receive_skb genl_rcv __netif_receive_skb_one_core netlink_rcv_skb NF_HOOK genl_rcv_msg ip_local_deliver_finish genl_family_rcv_msg ip_protocol_deliver_rcu genl_family_rcv_msg_doit tcp_v4_rcv mptcp_pm_nl_flush_addrs_doit tcp_v4_do_rcv mptcp_nl_remove_addrs_list tcp_rcv_established mptcp_pm_remove_addrs_and_subflows tcp_data_queue remove_anno_list_by_saddr mptcp_incoming_options mptcp_pm_del_add_timer mptcp_pm_del_add_timer kfree(entry) In remove_anno_list_by_saddr(running on CPU2), after leaving the critical zone protected by "pm.lock", the entry will be released, which leads to the occurrence of uaf in the mptcp_pm_del_add_timer(running on CPU1). Keeping a reference to add_timer inside the lock, and calling sk_stop_timer_sync() with this reference, instead of "entry->add_timer". Move list_del(&entry->list) to mptcp_pm_del_add_timer and inside the pm lock, do not directly access any members of the entry outside the pm lock, which can avoid similar "entry->x" uaf.

In the Linux kernel, the following vulnerability has been resolved: net/mlx5: Fix bridge mode operations when there are no VFs Currently, trying to set the bridge mode attribute when numvfs=0 leads to a crash: bridge link set dev eth2 hwmode vepa [ 168.967392] BUG: kernel NULL pointer dereference, address: 0000000000000030 [...] [ 168.969989] RIP: 0010:mlx5_add_flow_rules+0x1f/0x300 [mlx5_core] [...] [ 168.976037] Call Trace: [ 168.976188] <TASK> [ 168.978620] _mlx5_eswitch_set_vepa_locked+0x113/0x230 [mlx5_core] [ 168.979074] mlx5_eswitch_set_vepa+0x7f/0xa0 [mlx5_core] [ 168.979471] rtnl_bridge_setlink+0xe9/0x1f0 [ 168.979714] rtnetlink_rcv_msg+0x159/0x400 [ 168.980451] netlink_rcv_skb+0x54/0x100 [ 168.980675] netlink_unicast+0x241/0x360 [ 168.980918] netlink_sendmsg+0x1f6/0x430 [ 168.981162] ____sys_sendmsg+0x3bb/0x3f0 [ 168.982155] ___sys_sendmsg+0x88/0xd0 [ 168.985036] __sys_sendmsg+0x59/0xa0 [ 168.985477] do_syscall_64+0x79/0x150 [ 168.987273] entry_SYSCALL_64_after_hwframe+0x76/0x7e [ 168.987773] RIP: 0033:0x7f8f7950f917 (esw->fdb_table.legacy.vepa_fdb is null) The bridge mode is only relevant when there are multiple functions per port. Therefore, prevent setting and getting this setting when there are no VFs. Note that after this change, there are no settings to change on the PF interface using `bridge link` when there are no VFs, so the interface no longer appears in the `bridge link` output.

In the Linux kernel, the following vulnerability has been resolved: netfilter: nft_socket: fix sk refcount leaks We must put 'sk' reference before returning.

In the Linux kernel, the following vulnerability has been resolved: net: dpaa: Pad packets to ETH_ZLEN When sending packets under 60 bytes, up to three bytes of the buffer following the data may be leaked. Avoid this by extending all packets to ETH_ZLEN, ensuring nothing is leaked in the padding. This bug can be reproduced by running $ ping -s 11 destination