In the Linux kernel, the following vulnerability has been resolved: clk: mediatek: mt7622-apmixedsys: Fix an error handling path in clk_mt8135_apmixed_probe() 'clk_data' is allocated with mtk_devm_alloc_clk_data(). So calling mtk_free_clk_data() explicitly in the remove function would lead to a double-free. Remove the redundant call.

In the Linux kernel, the following vulnerability has been resolved: net: ethernet: mtk_eth_soc: fix PPE hanging issue A patch to resolve an issue was found in MediaTek's GPL-licensed SDK: In the mtk_ppe_stop() function, the PPE scan mode is not disabled before disabling the PPE. This can potentially lead to a hang during the process of disabling the PPE. Without this patch, the PPE may experience a hang during the reboot test.

In the Linux kernel, the following vulnerability has been resolved: media: rkisp1: Fix IRQ handling due to shared interrupts The driver requests the interrupts as IRQF_SHARED, so the interrupt handlers can be called at any time. If such a call happens while the ISP is powered down, the SoC will hang as the driver tries to access the ISP registers. This can be reproduced even without the platform sharing the IRQ line: Enable CONFIG_DEBUG_SHIRQ and unload the driver, and the board will hang. Fix this by adding a new field, 'irqs_enabled', which is used to bail out from the interrupt handler when the ISP is not operational.

In the Linux kernel, the following vulnerability has been resolved: x86/mm: Ensure input to pfn_to_kaddr() is treated as a 64-bit type On 64-bit platforms, the pfn_to_kaddr() macro requires that the input value is 64 bits in order to ensure that valid address bits don't get lost when shifting that input by PAGE_SHIFT to calculate the physical address to provide a virtual address for. One such example is in pvalidate_pages() (used by SEV-SNP guests), where the GFN in the struct used for page-state change requests is a 40-bit bit-field, so attempts to pass this GFN field directly into pfn_to_kaddr() ends up causing guest crashes when dealing with addresses above the 1TB range due to the above. Fix this issue with SEV-SNP guests, as well as any similar cases that might cause issues in current/future code, by using an inline function, instead of a macro, so that the input is implicitly cast to the expected 64-bit input type prior to performing the shift operation. While it might be argued that the issue is on the caller side, other archs/macros have taken similar approaches to deal with instances like this, such as ARM explicitly casting the input to phys_addr_t: e48866647b48 ("ARM: 8396/1: use phys_addr_t in pfn_to_kaddr()") A C inline function is even better though. [ mingo: Refined the changelog some more & added __always_inline. ]

Uncontrolled resource consumption vulnerability in XAMPP Windows, versions 7.3.2 and earlier. This vulnerability exists when XAMPP attempts to process many incomplete HTTP requests, resulting in resource consumption and system crashes.

A vulnerability was found in Emlog Pro 2.3.4. It has been classified as problematic. This affects an unknown part of the component Cookie Handler. The manipulation of the argument AuthCookie leads to improper authentication. It is possible to initiate the attack remotely. The complexity of an attack is rather high. The exploitability is told to be difficult. The exploit has been disclosed to the public and may be used. The identifier VDB-264741 was assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

A vulnerability was found in Emlog Pro 2.3.4 and classified as critical. Affected by this issue is some unknown functionality of the file admin/setting.php. The manipulation leads to unrestricted upload. The attack may be launched remotely. The exploit has been disclosed to the public and may be used. The identifier of this vulnerability is VDB-264740. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.

In the Linux kernel, the following vulnerability has been resolved: cpumap: Zero-initialise xdp_rxq_info struct before running XDP program When running an XDP program that is attached to a cpumap entry, we don't initialise the xdp_rxq_info data structure being used in the xdp_buff that backs the XDP program invocation. Tobias noticed that this leads to random values being returned as the xdp_md->rx_queue_index value for XDP programs running in a cpumap. This means we're basically returning the contents of the uninitialised memory, which is bad. Fix this by zero-initialising the rxq data structure before running the XDP program.

In the Linux kernel, the following vulnerability has been resolved: netrom: Fix data-races around sysctl_net_busy_read We need to protect the reader reading the sysctl value because the value can be changed concurrently.

In the Linux kernel, the following vulnerability has been resolved: net: mctp: take ownership of skb in mctp_local_output Currently, mctp_local_output only takes ownership of skb on success, and we may leak an skb if mctp_local_output fails in specific states; the skb ownership isn't transferred until the actual output routing occurs. Instead, make mctp_local_output free the skb on all error paths up to the route action, so it always consumes the passed skb.

In the Linux kernel, the following vulnerability has been resolved: ipv6: fix potential "struct net" leak in inet6_rtm_getaddr() It seems that if userspace provides a correct IFA_TARGET_NETNSID value but no IFA_ADDRESS and IFA_LOCAL attributes, inet6_rtm_getaddr() returns -EINVAL with an elevated "struct net" refcount.

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_event: Fix handling of HCI_EV_IO_CAPA_REQUEST If we received HCI_EV_IO_CAPA_REQUEST while HCI_OP_READ_REMOTE_EXT_FEATURES is yet to be responded assume the remote does support SSP since otherwise this event shouldn't be generated.

In the Linux kernel, the following vulnerability has been resolved: netfilter: bridge: confirm multicast packets before passing them up the stack conntrack nf_confirm logic cannot handle cloned skbs referencing the same nf_conn entry, which will happen for multicast (broadcast) frames on bridges. Example: macvlan0 | br0 / \ ethX ethY ethX (or Y) receives a L2 multicast or broadcast packet containing an IP packet, flow is not yet in conntrack table. 1. skb passes through bridge and fake-ip (br_netfilter)Prerouting. -> skb->_nfct now references a unconfirmed entry 2. skb is broad/mcast packet. bridge now passes clones out on each bridge interface. 3. skb gets passed up the stack. 4. In macvlan case, macvlan driver retains clone(s) of the mcast skb and schedules a work queue to send them out on the lower devices. The clone skb->_nfct is not a copy, it is the same entry as the original skb. The macvlan rx handler then returns RX_HANDLER_PASS. 5. Normal conntrack hooks (in NF_INET_LOCAL_IN) confirm the orig skb. The Macvlan broadcast worker and normal confirm path will race. This race will not happen if step 2 already confirmed a clone. In that case later steps perform skb_clone() with skb->_nfct already confirmed (in hash table). This works fine. But such confirmation won't happen when eb/ip/nftables rules dropped the packets before they reached the nf_confirm step in postrouting. Pablo points out that nf_conntrack_bridge doesn't allow use of stateful nat, so we can safely discard the nf_conn entry and let inet call conntrack again. This doesn't work for bridge netfilter: skb could have a nat transformation. Also bridge nf prevents re-invocation of inet prerouting via 'sabotage_in' hook. Work around this problem by explicit confirmation of the entry at LOCAL_IN time, before upper layer has a chance to clone the unconfirmed entry. The downside is that this disables NAT and conntrack helpers. Alternative fix would be to add locking to all code parts that deal with unconfirmed packets, but even if that could be done in a sane way this opens up other problems, for example: -m physdev --physdev-out eth0 -j SNAT --snat-to 1.2.3.4 -m physdev --physdev-out eth1 -j SNAT --snat-to 1.2.3.5 For multicast case, only one of such conflicting mappings will be created, conntrack only handles 1:1 NAT mappings. Users should set create a setup that explicitly marks such traffic NOTRACK (conntrack bypass) to avoid this, but we cannot auto-bypass them, ruleset might have accept rules for untracked traffic already, so user-visible behaviour would change.

In the Linux kernel, the following vulnerability has been resolved: rtnetlink: fix error logic of IFLA_BRIDGE_FLAGS writing back In the commit d73ef2d69c0d ("rtnetlink: let rtnl_bridge_setlink checks IFLA_BRIDGE_MODE length"), an adjustment was made to the old loop logic in the function `rtnl_bridge_setlink` to enable the loop to also check the length of the IFLA_BRIDGE_MODE attribute. However, this adjustment removed the `break` statement and led to an error logic of the flags writing back at the end of this function. if (have_flags) memcpy(nla_data(attr), &flags, sizeof(flags)); // attr should point to IFLA_BRIDGE_FLAGS NLA !!! Before the mentioned commit, the `attr` is granted to be IFLA_BRIDGE_FLAGS. However, this is not necessarily true fow now as the updated loop will let the attr point to the last NLA, even an invalid NLA which could cause overflow writes. This patch introduces a new variable `br_flag` to save the NLA pointer that points to IFLA_BRIDGE_FLAGS and uses it to resolve the mentioned error logic.

In the Linux kernel, the following vulnerability has been resolved: efi/capsule-loader: fix incorrect allocation size gcc-14 notices that the allocation with sizeof(void) on 32-bit architectures is not enough for a 64-bit phys_addr_t: drivers/firmware/efi/capsule-loader.c: In function 'efi_capsule_open': drivers/firmware/efi/capsule-loader.c:295:24: error: allocation of insufficient size '4' for type 'phys_addr_t' {aka 'long long unsigned int'} with size '8' [-Werror=alloc-size] 295 | cap_info->phys = kzalloc(sizeof(void *), GFP_KERNEL); | ^ Use the correct type instead here.

In the Linux kernel, the following vulnerability has been resolved: power: supply: bq27xxx-i2c: Do not free non existing IRQ The bq27xxx i2c-client may not have an IRQ, in which case client->irq will be 0. bq27xxx_battery_i2c_probe() already has an if (client->irq) check wrapping the request_threaded_irq(). But bq27xxx_battery_i2c_remove() unconditionally calls free_irq(client->irq) leading to: [ 190.310742] ------------[ cut here ]------------ [ 190.310843] Trying to free already-free IRQ 0 [ 190.310861] WARNING: CPU: 2 PID: 1304 at kernel/irq/manage.c:1893 free_irq+0x1b8/0x310 Followed by a backtrace when unbinding the driver. Add an if (client->irq) to bq27xxx_battery_i2c_remove() mirroring probe() to fix this.

In the Linux kernel, the following vulnerability has been resolved: drm/nouveau: keep DMA buffers required for suspend/resume Nouveau deallocates a few buffers post GPU init which are required for GPU suspend/resume to function correctly. This is likely not as big an issue on systems where the NVGPU is the only GPU, but on multi-GPU set ups it leads to a regression where the kernel module errors and results in a system-wide rendering freeze. This commit addresses that regression by moving the two buffers required for suspend and resume to be deallocated at driver unload instead of post init.

In the Linux kernel, the following vulnerability has been resolved: wifi: nl80211: reject iftype change with mesh ID change It's currently possible to change the mesh ID when the interface isn't yet in mesh mode, at the same time as changing it into mesh mode. This leads to an overwrite of data in the wdev->u union for the interface type it currently has, causing cfg80211_change_iface() to do wrong things when switching. We could probably allow setting an interface to mesh while setting the mesh ID at the same time by doing a different order of operations here, but realistically there's no userspace that's going to do this, so just disallow changes in iftype when setting mesh ID.

In the Linux kernel, the following vulnerability has been resolved: dmaengine: dw-edma: HDMA: Add sync read before starting the DMA transfer in remote setup The Linked list element and pointer are not stored in the same memory as the HDMA controller register. If the doorbell register is toggled before the full write of the linked list a race condition error will occur. In remote setup we can only use a readl to the memory to assure the full write has occurred.

In the Linux kernel, the following vulnerability has been resolved: dmaengine: dw-edma: eDMA: Add sync read before starting the DMA transfer in remote setup The Linked list element and pointer are not stored in the same memory as the eDMA controller register. If the doorbell register is toggled before the full write of the linked list a race condition error will occur. In remote setup we can only use a readl to the memory to assure the full write has occurred.